Fagor CNC 8065 - Variables Related to Axis and Spindle Machine Parameters

·580·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to axis and spindle machine parameters.
10.6 Variables related to axis and spindle machine parameters.
BELONGING TO THE CHANNEL.
(V.)[ch].MPA.AXISEXCH.xn
(V.)[ch].MPA.AXISEXCH.sn
(V.)[ch].SP.AXISEXCH.sn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Channel [ch]. Channel change permission.
This variable shows whether it is possible for the axis or spindle to change channels via part-
program and, if so, whether the change is temporary or permanent; in other words, whether
the change is maintained after an M02, M30 or a reset.
Syntax.
·ch· Channel number.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
Values of the variable.
This variable returns one of the following values.
TYPE OF AXIS AND DRIVE.
(V.)[ch].MPA.AXISTYPE.xn
Variable that can only be read from the program, PLC and interface.
Variable that may be modified during setup.
Variable valid for rotary and linear axes.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the execution value; reading it interrupts block preparation.
Channel [ch]. Type of axis.
Syntax.
·ch· Channel number.
V.MPA.AXISEXCH.Z Z axis.
V.MPA.AXISEXCH.S Spindle S.
V.SP.AXISEXCH.S Spindle S.
V.SP.AXISEXCH Master spindle.
V.MPA.AXISEXCH.4 Axis or spindle with logic number ·4·.
V.[2].MPA.A XISEXCH.1 Axis with index ·1· in the channel ·2·.
V.SP.AXISEXCH.2 Spindle with index ·2· in the system.
V.[2].SP.AXISEXCH.1 Spindle with index ·1· in the channel ·2·.
Value. Meaning.
0 It is not possible to change the axis or the spindle of the
channel.
1 The change is temporary.
2 The change is permanent.