Fagor CNC 8065 - Variables Related to Machine Parameters for M Functions

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·675·
Variables related to machine parameters for M functions.
10.9 Variables related to machine parameters for M functions.
(V.)MPM.MTABLESIZE
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
"M" function table. Number of table elements.
(V.)MPM.MNUM[pos]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Position [pos] of the "M" function table. "M" function number.
If the variable returns a ·-1· value, it means that no "M" function has been defined in that
position.
Syntax.
·pos· Position inside the "M" function table.
(V.)MPM.SYNCHTYPE[pos]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Position [pos] of the "M" function table. Type of synchronism.
Since the M functions may be programmed together with the movement of the axes, in the
same block, it must be indicated when the function is to be sent out to the PLC and when
it will be checked that it has been already executed (synchronization). The M functions may
be sent and/or synchronized before or after the movement.
Syntax.
·pos· Position inside the "M" function table.
Values of the variable.
This variable returns one of the following values.
(V.)MPM.MPROGNAME[pos]
Variable to be read via interface.
Position [pos] of the "M" function table. Name of the associated subroutine.
(V.)MPM.MTIME[pos]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Position [pos] of the "M" function table. Estimated execution time (in milliseconds).
V.MPM.MTABLESIZE
V.MPM.MNUM[12] Position ·12· of the "M" function table.
V.MPM.SYNCHTYPE[12] Position ·12· of the "M" function table.
Value. Meaning.
0 Without synchronization.
2 The M function is both sent to the PLC and synchronized before the movement.
4 The M function is sent to the PLC before the movement and synchronized after the
movement.
8 The M function is both sent to the PLC and synchronized after the movement.
MPM.MPROGNAME[12] Position ·12· of the "M" function table.