Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·711·
PLC consulting logic signals; tool manager.
(V.)PLC.LEAVEPOS
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The manager indicates in this register the magazine position to leave the tool.
(V.)PLC.TAKEPOS
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The manager indicates in this register the magazine position of the tool to be picked up.
(V.)PLC.NEXTPOS
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The manager indicates in this register the magazine position of the next tool.
(V.)PLC.TWORNOUT
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The manager turns this mark on when it has rejected the tool.
V.PLC.LEAVEPOS Magazine ·1·.
V.PLC.LEAVEPOSMZ1 Magazine ·1·.
V.PLC.LEAVEPOSMZ2 Magazine ·2·.
V.PLC.LEAVEPOSMZ3 Magazine ·3·.
V.PLC.LEAVEPOSMZ4 Magazine ·4·.
V.PLC.TAKEPOS Magazine ·1·.
V.PLC.TAKEPOSMZ1 Magazine ·1·.
V.PLC.TAKEPOSMZ2 Magazine ·2·.
V.PLC.TAKEPOSMZ3 Magazine ·3·.
V.PLC.TAKEPOSMZ4 Magazine ·4·.
V.PLC.NEXTPOS Magazine ·1·.
V.PLC.NEXTPOSMZ1 Magazine ·1·.
V.PLC.NEXTPOSMZ2 Magazine ·2·.
V.PLC.NEXTPOSMZ3 Magazine ·3·.
V.PLC.NEXTPOSMZ4 Magazine ·4·.
V.PLC.TWONRNOUT Channel ·1·.
V.PLC.TWONRNOUTC1 Channel ·1·.
V.PLC.TWONRNOUTC2 Channel ·2·.
V.PLC.TWONRNOUTC3 Channel ·3·.
V.PLC.TWONRNOUTC4 Channel ·4·.
To Next Page
Loading...
