Fagor CNC 8065 - Page 712

·712·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC consulting logic signals; tool manager.
(V.)PLC.TMINEM
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The manager activates the mark when it is in an error state.
(V.)PLC.MZID
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The manager indicates in this register the magazine that has the requested tool. When two
magazines are involved in a tool change, the lower portion of this register indicates the
destination magazine for the tool and the higher portion the source magazine for the tool.
V.PLC.TMINEM Magazine ·1·.
V.PLC.TMINEMZ1 Magazine ·1·.
V.PLC.TMINEMZ2 Magazine ·2·.
V.PLC.TMINEMZ3 Magazine ·3·.
V.PLC.TMINEMZ4 Magazine ·4·.
V.PLC.MZID Channel ·1·.
V.PLC.MZIDC1 Channel ·1·.
V.PLC.MZIDC2 Channel ·2·.
V.PLC.MZIDC3 Channel ·3·.
V.PLC.MZIDC4 Channel ·4·.