Fagor CNC 8065 - Moving an Axis to a Particular Position (Coordinate)

Operating manual.
CNC 8060
CNC 8065
MANUAL (JOG) MODE
5.
Operations with the axes.
·125·
(REF: 1807)
5.2.4 Moving an axis to a particular position (coordinate)
Move an axis to a particular position (coordinate) via keyboard.
1 Select the axis to be moved using the alphanumeric keyboard. The CNC will highlight
that axis to indicate that it is selected.
To select the numbered axes (e.g. "X1"), select any axis and then move the selection until
positioning on the desired one. The focus moves with the [][] keys.
2 Enter the coordinate of the target point.
3 Press [START] to execute the movement or [ESC] to cancel the operation.
Move an axis to a particular position (coordinate) via softkey menu.
1 On the axis preset softkey of the horizontal menu, select an axis. The CNC will highlight
that axis to indicate that it is selected.
2 Enter the coordinate of the target point.
3 Press [START] to execute the movement or [ESC] to cancel the operation.
Feedrate behavior
The moving feedrate depends on whether G00 or G01 is active. This feedrate may be varied
between 0% and 200% using the feedrate override switch on the operator panel. The
percentage will be applied on to all the movements carried out in G00 and in G01.
• If G00 is active, the movement is carried out at the rapid rate defined by the machine
manufacturer.
• If G01 is active, the movement is carried out at the active feedrate. If no feedrate is active,
the movement is executed at the feedrate defined by the machine manufacturer.
5.2.5 Coordinate preset
The coordinates must be preset one axis at a time. The preset may be canceled by homing
the axes one by one or by means of function "G53".
Preset a position (coordinate) via keyboard.
1 Use the alphanumeric keyboard to select the axis whose position value (coordinate) is
to be preset. The CNC will highlight that axis to indicate that it is selected.
To select the numbered axes (e.g. "X1"), select any axis and then move the selection until
positioning on the desired one. The focus moves with the [][] keys.
2 Key in the desired preset value.
3 Press [ENTER] to preset the entered value or [ESC] to cancel the operation.
Preset a position (coordinate) via softkey menu.
1 On the axis preset softkey of the horizontal menu, select an axis. The CNC will highlight
that axis to indicate that it is selected.
2 Key in the desired preset value.
3 Press [ENTER] to preset the entered value or [ESC] to cancel the operation.