Operating manual.
CNC 8060
CNC 8065
EDISIMU MODE (EDITING AND SIMULATION)
8.
Working in the editing window.
·171·
(REF: 1807)
8.4.3 Find a line or a text in the program.
The "Operations with blocks" softkey is used to find a line or a text in the program and replace
a text with another one. When selecting this option, the CNC shows a dialog box requesting
the line number or the text to look for. When defining a text search, certain options may also
be defining that allow:
After defining the search options, press [ENTER] to start the search or [ESC] to cancel it.
The text found in the program will be highlighted and the softkey menu will show the following
options:
• "Replace" option, to replace the highlighted text.
• "Replace all" option, to replace the text throughout the whole program.
• "Find next" option, to skip this text and keep on searching.
• "Find previous" option, to look for the text without replacing it.
To end the search, press [ESC].
8.4.4 Undo and redo.
This softkey may be used to "undo" the last modifications made. The modifications are
undone one by one starting from the most recent one. The CNC offers the following keyboard
shortcuts to undo and redo the operations.
A Go to a line of the program.
B Replacing the text being searched with another
in the program.
C Ignore uppercase and lowercase.
D Consider the text to find as a whole word.
E Select whether the search starts at the
beginning of the program or at the cursor
position.
F Direction of the search.
[CTRL]+[Z] Undo the last change.
[CTRL]+[Y] Redo the selected text.
To Next Page
Loading...
