Fagor CNC 8065 - Chapter 10 Fcas (Fagor Collision Avoidance System); CHAPTER 11 Profile Editor

Operating manual.
CNC 8060
CNC 8065
EDISIMU MODE (EDITING AND SIMULATION)
8.
Working in the editing window.
·179·
(REF: 1807)
8.4.11 Profile editor.
The profile editor may be accessed from the softkey menu to edit a new one, or selecting
a profile of the program and pressing the [RECALL] key. The profile editor shows its options
on the softkey menu. See chapter
"11 Profile editor".
To return to editing the program, press "End". The softkey menu of the program editor shows
the "insert profile" softkey to insert the defined profile into the program. The block for the
defined profile is inserted after the block where the cursor is.
8.4.12 Canned cycle editor.
The cycle editor may be accessed from the softkey menu to edit a new one, or selecting a
cycle of the program and pressing the [RECALL] key. The softkey menu of the cycle editor
shows the available canned cycles.
To return to the program editor, press the [BACK] key. The softkey menu of the program editor
shows the "insert cycle" softkey to insert the defined cycle into the program. The block for
the defined cycle is inserted after the block where the cursor is.
Canned cycles have a specific manual both for milling and turning. Refer to the documentation included
in the CD-Rom that comes with the product for further detail.
BACK