Operating manual.
CNC 8060
CNC 8065
EDISIMU MODE (EDITING AND SIMULATION)
8.
Program window
·187·
(REF: 1807)
8.7 Program window
This window shows the contents of the program selected for simulation and allows selecting
the first and last blocks of the simulation. When not selected, the simulation will begin at the
first block of the block and will end after executing one of the end-of-program functions "M02"
or "M30". While simulating, the window cursor will show the block being simulated.
Description of the program window
The program window shows the following information:
A Title bar.
Name of the program selected for simulation.
B Program blocks selected for simulation.
While simulating, the cursor will indicate the block being simulated. The "active
subroutines" option being active, the window displays information related to the
execution of subroutines, canned cycles, repetition blocks and loops.
C Program line.
Line of the program where the cursor is.
Horizontal softkey menu.
When selecting the program window, the horizontal softkey menu will show the options
related to this window.
Softkey. Description.
Block selection. Select the first and last blocks of the execution.
Display. Toggle between the various screens of the EDISIMU mode and
display information related to the status of the subroutines, canned
cycles, repetition blocks and loops.
Exblk. Execute only the block selected with the cursor.
Graphics. Show the graphics screen.
To Next Page
Loading...
