Operating manual.
CNC 8060
CNC 8065
TOOL AND MAGAZINE TABLE
18.
Presentation of the tool tables and magazine tables.
·297·
(REF: 1807)
Order (sequence) to follow when loading the different tables.
As mentioned earlier, there are two ways to load the table data from the ASCII files; loading
all of them at the same time or selecting each table and loading its data.
Loading all the tables at the same time.
In this case, it is up to the CNC to set the order (sequence) used to load the data.
Order (sequence) to follow when loading the tables one by one.
This way, each table is selected and its data loaded. In this case, the following sequence must
be followed when loading the tables.
1 First load the tool table.
This table defines the system tools. Loading the tool table initializes the tables of the
magazines and the active-tools table.
2 Second, load the tool magazine tables.
Since the tool list has changed, if the magazine tables are not loaded, it is not possible
to assure that the new tools are the ones located in the magazine tool or in the active-
tools table.
3 Finally, load the active-tools table.
When loading the tables of magazines, it is unsure that the current tool positions will be
compatible with the active tools.
To Next Page
Loading...
