Operating manual.
CNC 8060
CNC 8065
18.
TOOL AND MAGAZINE TABLE
Presentation of the tool tables and magazine tables.
·298·
(REF: 1807)
18.1.4 Printing the tables
Some of the tables may be printed in a printer accessible from the CNC or as a file (PRN
format). When the tables are saved as a file, it may be saved at the CNC, in a floppy disk
or at any other device (CNC, PC, etc.) connected through Ethernet. By default, the files are
saved in the folder "C:\CNC8070\ USERS\ Reports".
In either case, the action is carried out from the vertical softkey menu.
After selecting the target, press [ENTER] to start printing. Press [ESC] to cancel the
selection.
This softkey starts printing. When pressing this icon, the CNC will show a dialog
box requesting the print destination for the table (printer or file).
To Next Page
Loading...
