Operating manual.
CNC 8060
CNC 8065
TOOL AND MAGAZINE TABLE
18.
Operations with the magazine table
·325·
(REF: 1807)
18.9 Operations with the magazine table
18.9.1 Loading / unloading tools to / from the magazine
The tools may be loaded and unloaded to/from the magazine manually or automatically.
When done manually, the positions list must be updated.
Manual load/unload
The operator places the tools directly in the magazine without using the CNC. Then, the
positions list must be updated.
Automatic load/unload
The operator places the tools in the spindle and the CNC places the tool in the magazine.
The positions list is updated automatically.
Initialize table
The table can only be initialized when the CNC is "READY". The table is initialized from the
vertical softkey menu. The CNC offers two ways to initialize the table.
Load a tool
Depending on tool size, when it is loaded into the magazine, it may affect several positions.
Magazine management using the "Load tool" softkey.
This type of management is valid for loading tools both automatically and manually. After
pressing the softkey, the user is asked what kind of loading to do.
1 Press the softkey associated with tool loading.
2 Enter the tool number and the magazine position to insert it. By default, it offers the
position selected on the list with the cursor.
3 Press the [CYCLE START] key to load the tool automatically by means of the spindle
or the [ENTER] key to update the positions list after loading manually.
• Automatic loading (pressing [START]). The CNC loads into the magazine a tool
previously defined in the table. It is loaded from ground through the spindle.
• Manual loading (pressing [ENTER]). The CNC assume that the tool defined in the
table has already been manually loaded into the magazine. It updates the magazine
list.
Initializing the table eliminates all the data about the position of the tools in the
magazine. It also initializes the active-tools table because the tool arrangement
in the magazine has been changed.
When initializing the table, It initializes the magazine positions assigning T1 to
position 1, T2 to position 2 and so on. The tools must exist and must not be in
another magazine.
It also initializes the active-tools table because the tool arrangement in the
magazine may have changed.
The tool is loaded into the magazine using the vertical softkey menu. Only the
tools defined in the tool table may be loaded into the magazine and they must be
defined as ground tools. In other words, they must not be in any position of the
magazine, of the spindle or in the claws of the tool changer.
Even if the magazines are configured for not admitting ground tools while machining, they may be
loaded into the magazine through this maneuver.
To Next Page
Loading...
