Operating manual.
CNC 8060
CNC 8065
SETUP ASSISTANCE
22.
The Bode diagram
·419·
(REF: 1807)
Horizontal softkey menu
When defining a new graphic configuration and modified parameters, the system permits
saving that configuration in a file. Likewise, the system allows loading a configuration that
was saved previously or resetting the current configuration.
• Save the current configuration.
After pressing the "Save" softkey, the CNC shows the list of available configurations and
lets you save the current configuration. The file extension must be bod.
• It loads a previously saved configuration.
After pressing the "Load" softkey, the CNC shows the list of previously saved
configurations and lets you select any of the them.
• Reset or initialize the current configuration.
Pressing the "Reset" softkey of the configuration screen deletes or initializes the current
configuration. There are neither variables nor parameters selected and the rest of
conditions assume the values assigned by default.
• Activate/Cancel reference capture.
It may be used to activate or cancel the configuration of the reference Bode.
To Next Page
Loading...
