Programming manual
88
CNC 8070
5.
TECHNOLOGICAL FUNCTIONS
Tool number (T)
(SOFT V02.0X)
78
Loading a tool in a system with several magazines
When using more than one tool magazine, one must indicate in which
one of them the tool is to be loaded using the codeMZn, where n
indicates the magazine number. It must always be programmed in the
same block as Tn.
Considerations
The machine manufacturer may have associated a subroutine with the
"T" code, that will be executed automatically when selecting the tool.
If the M06 has been included in this subroutine, the tool will be loaded
into the spindle when executing the "T" code.
T1 MZ1 M6
(Place tool 1 in the first magazine)
T8 MZ2 POS17 M6
(Place tool 8 in position 17 of the second magazine)
To Next Page
Loading...
