Programming manual
120
CNC 8070
6.
TOOL PATH CONTROL
Rapid traverse (G00)
(SOFT V02.0X)
90
Feedrate behavior
A G00 movement temporarily cancels the programmed "F" and the
rapid traverse movement is carried out at the value set by the machine
manufacturer [A.M.P. "G00FEED"]. The "F" value is restored when
programming a G01, G02 or G03 type function.
When several axes are involved, the resulting feedrate is calculated
so at least one of the axis moves at its maximum speed.
When defining an "F" value and G00 in the same block, the CNC will
store the value assigned to "F" and it will apply it next time a G01, G02
or G03 type function is programmed.
The override percentage is set at 100% or may be varied between 0%
and 100% with the switch at the operator panel depending on how the
machine manufacturer has set [G.M.P. "RAPIDOVR"].
Properties of the function
Function G00 is modal and incompatible with G01, G02, G03, G33
and G63.
Function G00 may be programmed as G0.
On power-up, after an M02 or M30 and after an EMERGENCY or a
RESET, the CNC assumes function G00 or G01 as set by the machine
manufacturer [G.M.P. "IMOVE"].
To Next Page
Loading...
