Programming manual
120
CNC 8070
6.
TOOL PATH CONTROL
Circular interpolation (G02/G03)
(SOFT V02.0X)
96
Feedrate behavior
The programmed feedrate "F" stays active until a new value is
programmed, thus not being necessary to program it in every block.
The programmed feedrate "F" may be varied between 0% and 200%
using the selector switch on the CNC's operator panel or it may be
selected by program or by PLC. However, the maximum override is
limited by the machine manufacturer [G.M.P. "MAXOVR"].
Properties of the function
Functions G02 and G03 are modal and incompatible with each other
and with G00, G01, G33 and G63.
Function G74 (Home search) also cancels functions G02 and G03.
Functions G02 and G03 may also be programmed as G2 and G3.
On power-up, after an M02 or M30 and after an EMERGENCY or a
RESET, the CNC assumes function G00 or G01 as set by the machine
manufacturer [G.M.P. "IMOVE"].
To Next Page
Loading...
