Programming manual
144
CNC 8070
7.
GEOMETRY ASSISTANCE
Square corner (G07/G60)
(SOFT V02.0X)
122
Properties of the functions
Function G07 is modal and incompatible with G05, G50, G60, G61
and the HSC mode.
Function G60 is not modal. After it is executed, the CNC restores the
function G05, G07, G50 or HSC that was previously active.
On power-up, after executing M02 or M30 and after an EMERGENCY
or a RESET, the CNC assumes function G05, G07 or G50 as set by
the OEM [G.M.P. "ICORNER"].
To Next Page
Loading...
