Programming manual
CNC 8070
GEOMETRY ASSISTANCE
Controlled corner rounding, radius blend, (G05/G61)
7.
(SOFT V02.0X)
125
Properties of the functions
Function G05 is modal and incompatible with G07, G50, G60, G61
and the HSC mode.
Function G61 is not modal. After it is executed, the CNC restores the
function G05, G07, G50 or HSC that was previously active.
On power-up, after executing M02 or M30 and after an EMERGENCY
or a RESET, the CNC assumes function G05, G07 or G50 as set by
the OEM [G.M.P. "ICORNER"].
To Next Page
Loading...
