Programming manual
CNC 8070
GEOMETRY ASSISTANCE
Controlled corner rounding, radius blend, (G05/G61)
7.
(SOFT V02.0X)
129
This type of corner rounding only uses the values of the first six
parameters of the "#ROUNDPAR" instruction.
In this type of corner rounding, the shape of the curve depends on the
position of the intermediate point and on the distance from the
programmed point to the starting and ending points of the corner
rounding.
...
G92 X0 Y0
G71 G90
#ROUNDPAR [5,-30,-30,55,-5,0]
G01 G61 X50 F850
N90 G01 Y40
...
"a" and "b" distances negative and greater (in absolute value) than the
distance from the programmed point to the intermediate point on each axis
(about 4 times).
...
G92 X0 Y0
G71 G90
#ROUNDPAR [5,-5,-5.65,-15.0]
G01 G61 X50 F850
G01 Y40
...
"a" and "b" distances, negative and smaller (in absolute value) than the
distance from the programmed point to the intermediate point on each axis.
...
G92 X0 Y0
G71 G90
#ROUNDPAR [5,5,5,65,-15,0]
G01 G61 X50 F850
G01 Y40
...
Positive "a" and "b" distances.
(Px, Py, Pz)
to
b
to
b
(Px, Py, Pz)
to
b
(Px, Py, Pz)
to
b
(Px, Py, Pz)
To Next Page
Loading...
