Programming manual
144
CNC 8070
7.
GEOMETRY ASSISTANCE
Mirror image (G11, G12, G13, G10, G14)
(SOFT V02.0X)
136
7.8 Mirror image (G11, G12, G13, G10, G14)
Mirror image may be used to repeat the programmed machining
operation in a symmetrical position with respect one or more axes.
When using with mirror image, the movements of the axes where
mirror image is applied are executed with the opposite sign.
Programming
Mirror image may be applied by program using these functions:
G10 Mirror image cancellation.
G11 Mirror image in X.
G12 Mirror image in Y.
G13 Mirror image in Z.
G14 Mirror image in the programmed directions.
G10 Mirror image cancellation
It cancels mirror image on all axes, including the mirror image
activated with G14.
If it is added to a path defining block, the mirror image will be canceled
before the movement.
G11 to G13 Mirror image on X, on Y or on Z
Functions G11, G12 and G13 activate mirror image on the X, Y and
Z axis respectively. These functions do not cancel each other, thus
being possible to keep mirror image active on several axes at the same
time.
If they are added to a path defining block, the mirror image will be
activated before the movement.
G11
(Mirror image on the X axis)
G12
(Mirror image on the Y axis. The one on the X axis remains active)
···
G10
(Mirror image cancellation on all the axes)
To Next Page
Loading...
