Programming manual
144
CNC 8070
7.
GEOMETRY ASSISTANCE
Coordinate system rotation, pattern rotation, (G73)
(SOFT V02.0X)
140
Considerations
Function G73 is incremental; i.e. the various "Q" values programmed
are added up.
The "I" and "J" values are affected by the active mirror images. If any
mirror image function is active, the CNC applies first the mirror image
and then the coordinate system rotation.
Properties of the function
Function G73 is modal. The coordinate rotation stays active until it is
canceled by function G73 or until the work plane is changed.
On power-up, after executing an M02 or M30, and after an
EMERGENCY or RESET, the CNC cancels the active coordinate
system (pattern) rotation.
To Next Page
Loading...
