Programming manual
174
CNC 8070
9.
TOOL COMPENSATION
(SOFT V02.0X)
156
Compensation values
The compensation values applied in each case is calculated from the
tool dimensions.
• In tool radius compensation, the applied value is the sum of the
radius and radius wear of the selected tool.
• In tool length compensation, the applied value is the sum of the
length and length wear of the selected tool.
The tool "T" and the tool offset "D", containing the tool dimensions,
may be selected anywhere in the program, even while tool
compensation is active. If no tool offset is selected, the CNC assumes
tool offset "D1".
To Next Page
Loading...
