Programming manual
CNC 8070
CANNED CYCLES
G82. Drilling canned cycle with variable peck
10.
(SOFT V02.0X)
185
C Approach coordinate.
It defines the rapid approach (G0) distance of the longitudinal
axis from the previous drilling peck to carry out a new drilling
peck.
If not programmed, it assumes 1 mm.
It issues an error message if "C=0" is programmed.
J It defines after how many drilling pecks the tool returns in rapid
(G0) to the reference plane (Z).
With "J" greater than 1, after each peck, the tool returns the
distance indicated by "H" and every "J" pecks to the reference
plane (Z).
With "J=1", it returns to the reference plane (Z) after each peck.
If "J" is not programmed or "J=0" is programmed, it returns to
the relief coordinate indicated by "H" after each peck.
K Dwell, in seconds, at the bottom of the hole.
If not defined, it assumes a value of 0.
R Factor that increases or reduces the drilling peck (step) "B".
The first peck will be "B", the second "RB", the third "R(RB)"
and so on.
If it is not programmed or "R=0" is programmed, it assumes
"R=1". With "R=1", all the drilling pecks will have the value of
"B".
L Minimum value for the drilling peck. It is used with "R" values
other than 1. If not programmed or programmed with a 0 value,
it assumes the value of 1 mm.
To Next Page
Loading...
