Programming manual
CNC 8070
CANNED CYCLES
G84. Tapping canned cycle
10.
(SOFT V02.0X)
193
Basic operation:
1. If the spindle was previously running, it maintains the turning
direction. If it is stopped, it starts clockwise (M03).
2. Rapid movement (G0) of the longitudinal axis from the starting
plane (Zi) to the reference plane (Z).
3. Tapping. It is executed at 100% of the feedrate "F" and spindle
speed "S" programmed. Tapping cannot be interrupted.
4. If "K" other than 0, spindle stop (M05) and dwell.
5. Reverse the spindle turning direction.
Withdrawal, exit the tap, to the reference plane. At 100% of the
feedrate "F" and spindle speed "S" programmed. The thread exit
cannot be interrupted.
6. Depending on the type of tap programmed.
7. If function G98 is active, rapid withdraw to the starting plane (Zi).
R=0 Reverse the spindle turning direction restoring the initial turning
direction.
R=1 Spindle orientation (M19).
To Next Page
Loading...
