Programming manual
210
CNC 8070
10.
CANNED CYCLES
G87. Rectangular pocket canned cycle.
(SOFT V02.0X)
200
M Type of corner. (0) square, (1) rounded, (2) chamfered. If not
programmed, it assumes a value of 0.
Q Rounding radius or chamfer size.
B Depth of pass.
If programmed with a positive sign (B+), the cycle recalculates
the step so all the penetrations are identical with the same
value as or smaller than the one programmed.
If programmed with a negative sign (B-), the pocket is
machined with the given pass (step) except the last pass that
machines the rest.
C Milling pass or width.
If not programmed or programmed with a 0 value, it assumes
a value of 3/4 of the diameter of the selected tool.
If it is the same as parameter "J" or "K" (half length/half width
of the pocket) it only runs the finishing pass.
If programmed with a value greater than the tool diameter, the
CNC issues the relevant error message.
L Finishing pass.
If not programmed or programmed with a 0 value, it does not
run the finishing pass.
To Next Page
Loading...
