Programming manual
CNC 8070
MULTIPLE MACHINING
G160. Multiple machining in straight line
11.
(SOFT V02.0X)
213
11.1 G160. Multiple machining in straight line
The programming format for this cycle is:
When defining the machining operation, only two of parameters "X",
"I" and "K" are required.
G160 A X I P Q R S T U V
X K
I K
A Angle, in degrees of the machining path with respect to the
abscissa axis.
If not programmed, a value of A = 0 is assumed.
X Length of the machining path.
I Step between machining operations.
K Total number of machining operations in the section, including
that of the machining definition point.
X I X K I K
When selecting the "X-I" format, bear in mind that the resulting number of
machining operations must be an integer, otherwise, the CNC will issue
the relevant error message.
To Next Page
Loading...
