Programming manual
232
CNC 8070
11.
MULTIPLE MACHINING
G161. Multiple machining in rectangular pattern
(SOFT V02.0X)
216
11.2 G161. Multiple machining in rectangular pattern
The programming format for this cycle is:
When defining the length of the parallelogram, only two of parameters
"X", "I" and "K" are required.
G161 A B X I Y J P Q R S T U V
X K Y D
I K J D
A Angle, in degrees of the machining path with respect to the
abscissa axis.
If not programmed, a value of A = 0 is assumed.
B Angle between both machining paths.
If not programmed, a value of B = 90 is assumed.
X Length of the parallelogram.
I Step between machining operations along the path.
K Total number of machining operations along the path,
including that of the machining definition point.
X I X K I K
When selecting the "X-I" format, bear in mind that the resulting number of
machining operations must be an integer, otherwise, the CNC will issue
the relevant error message.
To Next Page
Loading...
