12
233
CNC 8070
(SOFT V02.0X)
CYCLE EDITOR
12.1 General concepts
The cycles integrated into the cycle editor are grouped as follows:
Machining canned cycles.
• Drilling:
Center punching, Drilling 1, Drilling 2
• Tapping.
• Reaming
• Boring
Boring 1, Boring 2
• Pockets
Pocket: Simple, Rectangular, Circular, Pre-emptied, 2D, 3D
• Bosses
Boss: Rectangular, Circular
• Surface milling
• Profile milling
Point-to-point profile, Profile
• Slot milling
Multiple machining.
• Linear.
• Arc.
• Rectangle.
• Grid.
• Random (several points defined by the user).
Multiple machining may be associated with canned cycles so it can
be repeated in several points.
To Next Page
Loading...
