Fagor CNC 8070 - Page 268



 Programming manual
326
CNC 8070
12.
CYCLE EDITOR
General concepts
(SOFT V02.0X)
234
Execution
While executing these canned cycles, the CNC shows the following
"G" functions in the window for active functions.
G281 Center punching.
G282 Drilling 1.
G283 Drilling 2.
G284 Tapping.
G285 Reaming.
G286 Boring 1.
G297 Boring 2.
G287 Rectangular pocket.
G288 Circular pocket.
G289 Simple pocket.
G296 Pre-emptied pocket.
G291 Rectangular boss.
G292 Circular boss.
G290 Surface milling.
G293 Point-to-point profile.
G294 Profile.
G295 Slot milling.