Programming manual
CNC 8070
CYCLE EDITOR
General concepts
12.
(SOFT V02.0X)
235
12.1.1 Associate a multiple machining operation with a canned cycle
A multiple machining operation may be associated with the following
cycles:
• Center punching, Drilling 1, Drilling 2, Tapping, Reaming, Boring
1, Boring 2.
• simple, rectangular, circular and pre-emptied pocket.
• rectangular and circular boss.
However, no multiple machining operation may be associated with the
following cycles.
• 2D and 3D pockets, Surface milling, Profile, Point-to-point profile
and Slot milling.
To associate a multiple machining operation with a cycle:
1. Select and define the canned cycle.
2. Press the "Multiple" softkey.
3. Select the desired multiple machining operation.
The next figure shows the Drilling 1 cycle (top) with a multiple linear
machining operation associated to it (bottom).
To edit the data of the canned cycle or of the multiple machining
operation, select the relevant window using the
(a)
key.
When the canned cycle takes up the whole screen, the multiple
machining operation is super-imposed on it as shown in the figure.
(a)
To Next Page
Loading...
