Programming manual
326
CNC 8070
12.
CYCLE EDITOR
General concepts
(SOFT V02.0X)
236
In these cases, while editing the cycle data, the top window is shifted
automatically to show the data.
The canned cycle editing windows are generic. They do not depend
on the active work plane.
The canned cycles have no work plane associated to them, they are
executed in the current active work plane.
The same nomenclature as for the G17 work plane has been used.
X abscissa axis.
Y ordinate axis.
Z longitudinal axis.
When working in another plane, one must:
• Select the proper work plane.
G17, G18, G19 or instruction #SET AX.
• Select longitudinal axis and machining direction.
Instruction #TOOL AX.
• Program the cycles considering the previous nomenclature.
i
To Next Page
Loading...
