Fagor CNC 8070 - Center Punching



 Programming manual
CNC 8070
CYCLE EDITOR
Center punching
12.
(SOFT V02.0X)
243
12.2 Center punching
Geometric parameters:
Depth programming type (icon).
Machining parameters:
Spindle turning direction (icon).
Clockwise with icon
(c)
and counterclockwise with icon
(d)
X, Y Machining point.
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth. With icon
(a)
.
το Center-punching angle. With icon
(b)
.
φ Center-punching diameter. With icon
(b)
.
With Z=Zs and icon
(b)
the machining direction is always
towards Z(-)
F Feedrate.
S Spindle speed.
TTool.
D Tool offset.
t Dwell at the bottom, in seconds.
(b)(a)
(d)(c)