Programming manual
CNC 8070
CYCLE EDITOR
Drilling 1.
12.
(SOFT V02.0X)
245
12.3 Drilling 1.
Geometric parameters:
Machining parameters:
Spindle turning direction (icon).
Clockwise with icon
(a)
and counterclockwise with icon
(b)
X, Y Machining point.
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
I Penetration step. The drilling takes place with the given step,
except the last step that machines the rest.
Zr Relief coordinate it returns to, in rapid (G0), after each drilling
step.
If it has not reached the "Zr" coordinate, it returns to the
approach plane.
F Feedrate.
S Spindle speed.
TTool.
D Tool offset.
t Dwell at the bottom, in seconds.
(b)(a)
To Next Page
Loading...
