Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Drilling 2.
(SOFT V02.0X)
248
Basic operation:
1. It starts the spindle in the requested direction.
2. Rapid movement (G0), up to the XY point and the safety plane (Zs).
Depending on the starting plane, it first moves in XY and then in
Z or vice versa.
3. Rapid movement (G0) up to the approach plane.
4. It penetrates the distance "I" at the feedrate "F".
5. Drilling loop until reaching the total depth "P".
5.1. It withdraws in rapid (G0) the relief distance "B".
5.2. Rapid approach (G0) up to 1 mm from the previous drilling
step (peck).
5.3. It penetrates the distance "I" at the feedrate "F".
6. Dwell "t".
7. Rapid withdrawal (G0) up to the safety plane (Zs).
If it has a multiple machining operation associated with it, it executes
the following steps as often as necessary:
8. Rapid movement (G0) to the next point.
9. Repeats steps 3, 4, 5, 6, 7.
To Next Page
Loading...
