Fagor CNC 8070 - Chapter 18 PLC; Appearance of the PLC mode



 Programming manual
CNC 8070
CYCLE EDITOR
Boring 1.
12.
(SOFT V02.0X)
253
12.7 Boring 1.
Geometric parameters:
Machining parameters:
Type of withdrawal (icon).
At feedrate "F" and the spindle turning. Icon
(a)
.
In rapid (G0) with the spindle stopped. Icon
(b)
.
Spindle turning direction (icon).
Clockwise with icon
(c)
and counterclockwise with icon
(d)
X, Y Machining point.
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
F Feedrate.
S Spindle speed.
TTool.
D Tool offset.
t Dwell at the bottom, in seconds.
(b)(a)
(d)(c)