Programming manual
CNC 8070
CYCLE EDITOR
Simple pocket.
12.
(SOFT V02.0X)
257
12.9 Simple pocket.
The way the roughing and finishing blocks of this cycle are joined will
be the one previously set by the user with the instructions #HSC, G5,
G50 or G7. We recommend to use #HSC or G5 controlling the shape
of the corner with the instruction #ROUNDPAR.
Geometric parameters:
Machining parameters:
X, Y Pocket corner.
L, H Pocket dimensions.
The sign indicates the orientation referred to the XY point.
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
∆ Maximum milling pass or width.
The cycle recalculates the pass so that all the passes are
identical, with the same value as or smaller than the one
programmed.
If programmed with a 0 value, it assumes a value of 3/4 of the
diameter of the selected tool.
To Next Page
Loading...
