Fagor CNC 8070 - Program editing



 Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Simple pocket.
(SOFT V02.0X)
258
Spindle turning direction (icon).
Clockwise with icon
(a)
.
Counterclockwise with icon
(b)
.
Machining direction (icon).
Clockwise with icon
(c)
.
Counterclockwise with icon
(d)
.
δ Finishing stock on the side walls.
I Penetration step.
• If programmed with a positive sign (I+), the cycle
recalculates the step so all the penetrations are identical
with the same value as or smaller than the one programmed.
• If programmed with a negative sign (I-), the pocket is
machined with the given pass (step) except the last pass
that machines the rest.
In either case, the cycle limits the step to the cutting length
assigned to the tool in the tool table.
Fz Penetration feedrate.
F Surface milling feedrate.
S Spindle speed.
T Tool.
D Tool offset.
(b)(a)
(d)(c)