Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Rectangular pocket
(SOFT V02.0X)
260
12.10 Rectangular pocket
The way the roughing and finishing blocks of this cycle are joined will
be the one previously set by the user with the instructions #HSC, G5,
G50 or G7. We recommend to use #HSC or G5 controlling the shape
of the corner with the instruction #ROUNDPAR.
Geometric parameters:
Type of corner (icon).
Square corner with icon
(a)
.
Rounded corner with icon
(b)
.
Chamfered corner with icon
(c)
.
X, Y Pocket corner.
L, H Pocket dimensions.
The sign indicates the orientation referred to the XY point.
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
το Angle, in degrees, between the pocket and the abscissa axis.
The turn is carried out on the defined corner, X,Y point.
r Rounding radius or chamfer size.
(b)(a)
(c)
To Next Page
Loading...
