Programming manual
CNC 8070
CYCLE EDITOR
Rectangular pocket
12.
(SOFT V02.0X)
261
Roughing parameters:
The roughing operation empties the pocket leaving the following
finishing stocks:
Both stocks are defined as finishing parameters.
The roughing operation defining parameters are:
δ Finishing stock on the side walls.
δz Finishing stock at the bottom of the pocket.
∆ Maximum milling pass or width.
The cycle recalculates the pass so that all the passes are
identical, with the same value as or smaller than the one
programmed.
If programmed with a 0 value, it assumes a value of 3/4 of the
diameter of the selected tool.
I Penetration step.
• If programmed with a positive sign (I+), the cycle
recalculates the step so all the penetrations are identical
with the same value as or smaller than the one programmed.
• If programmed with a negative sign (I-), the pocket is
machined with the given pass (step) except the last pass
that machines the rest.
In either case, the cycle limits the step to the cutting length
assigned to the tool in the tool table.
Fz Penetration feedrate.
β Penetrating angle.
The penetration is carried out in zigzag, starting and ending
at the center of the pocket.
If defined with a value greater than the one assigned to the tool
in the tool table, it assumes the table value.
F Surface milling feedrate.
To Next Page
Loading...
