Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Rectangular pocket
(SOFT V02.0X)
262
Spindle turning direction (icon).
Clockwise with icon
(d)
.
Counterclockwise with icon
(e)
.
Machining direction (icon).
Clockwise with icon
(f)
.
Counterclockwise with icon
(g)
.
Finishing parameters:
The finishing operation is carried out in two stages.
First, it machines the bottom of the pocket and then the side walls, with
tangential entry and exit.
The finishing operation defining parameters are:
S Spindle speed.
T Roughing tool.
If programmed T=0, there is no roughing.
δ Finishing stock on the side walls.
δz Finishing stock at the bottom of the pocket.
∆ Milling pass or width at the bottom of the pocket.
The cycle recalculates the pass so that all the passes are
identical, with the same value as or smaller than the one
programmed.
If programmed with a 0 value, it assumes a value of 3/4 of the
diameter of the selected tool.
N Number of penetration passes (steps) for the side finishing. If
the resulting step is greater than the cutting length assigned
to the table in the tool table, the step will be limited to that value.
(e)(d)
(g)(f)
To Next Page
Loading...
