Programming manual
CNC 8070
CYCLE EDITOR
Rectangular pocket
12.
(SOFT V02.0X)
263
Spindle turning direction (icon).
Clockwise with icon
(d)
.
Counterclockwise with icon
(e)
.
Machining direction (icon).
Clockwise with icon
(f)
.
Counterclockwise with icon
(g)
.
Basic operation:
1. It selects the roughing tool and starts the spindle in the requested
direction.
2. Rapid movement (G0) up to the safety plane (Zs) positioning at
the center of the pocket.
Depending on the tool position, it first moves in XY and then in Z
or vice versa.
θ Penetrating angle.
The penetration is carried out at the feedrate set by roughing
parameter "Fz" starting and ending at the center of the pocket.
If defined with a value greater than the one assigned to the tool
in the tool table, it assumes the table value.
F Surface and side milling feedrate.
S Spindle speed.
T Finishing tool.
If programmed T=0, there is no finishing.
D Tool offset.
(e)(d)
(g)(f)
To Next Page
Loading...
