Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Pre-emptied pocket
(SOFT V02.0X)
274
7. Finishing of the bottom of the pocket.
7.1. Penetration at feedrate "Fz" at an angle "θ".
7.2. Milling of the bottom of the pocket up to a distance "δ" from
the pocket wall. It is carried out at finishing feedrate "F" and,
if necessary, it recalculates the finishing pass (∆) so all the
passes are identical.
8. Withdrawal, in rapid (G0), to the center of the pocket in the
approach plane (1 mm off the "Z" surface).
9. Finishing of the side walls.
It is carried out in "N" passes at the finishing feedrate "F" and with
tangential entry and exit.
10.Rapid withdrawal (G0) to the center of the pocket in the safety
plane (Zs).
If it has a multiple machining operation associated with it, it executes
the following steps as often as necessary:
11.Rapid movement (G0) to the next point.
12.Repeats steps 3, 4, 5, 6, 7, 8, 9, 10.
To Next Page
Loading...
