Programming manual
CNC 8070
CYCLE EDITOR
2D pocket
12.
(SOFT V02.0X)
275
12.13 2D pocket
A pocket consists of an outside contour and a number of inside
contours called islands. All the walls of 2D pockets are vertical.
It is recommended to previously define the #ROUNDPAR instruction
in order to obtain a good finish because the finishing passes are
carried out in G05.
Geometric parameters:
The composition of the pocket and the profile in the plane is stored in
\ Cnc8070\ Users\ Profile.
pocket.P2D Pocket composition.
profile.PXY Plane profile.
P.2D Name of the 2D pocket.
Once the pocket configuration has been validated, the CNC
associates the geometry of the pocket to its name.
P.XY Name of the plane profile.
The profile must indicate the pocket's outside contour and
those of the islands.
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
To Next Page
Loading...
