Fagor CNC 8070 - Page 316



 Programming manual
326
CNC 8070
12.
CYCLE EDITOR
2D pocket
(SOFT V02.0X)
282
Configuration:
Profile (outside profile):
Corners
Profile P.XY FAGOR 102 Recall
Abscissa axis: X Ordinate axis: Y
Autozoom: Yes Validate
Starting point X 20 Y 0 Validate
Straight X 20 Y -40 Validate
Straight X 145 Y -40 Validate
Straight X 145 Y 40 Validate
Straight X 20 Y 40 Validate
Straight X 20 Y 0 Validate
Chamfer
Select the lower left corner Enter
Chamfer 15 Enter
Select the lower right corner Enter
Chamfer 15 Enter
Select the upper right corner Enter
Chamfer 15 Enter
Select the upper left corner Enter
Chamfer 15 Enter
Escape