Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Rectangular Boss
(SOFT V02.0X)
296
Roughing parameters:
The roughing operation machines the boss leaving the following
finishing stocks:
Both stocks are defined as finishing parameters.
The roughing operation defining parameters are:
Spindle turning direction (icon).
Clockwise with icon
(d)
.
Counterclockwise with icon
(e)
.
δ Finishing stock on the side walls.
δz Finishing stock at the base of the boss.
∆ Maximum milling pass or width.
The cycle recalculates the pass so that all the passes are
identical, with the same value as or smaller than the one
programmed.
If programmed with a 0 value, it assumes a value of 3/4 of the
diameter of the selected tool.
I Penetration step.
• If programmed with a positive sign (I+), the cycle
recalculates the step so all the penetrations are identical
with the same value as or smaller than the one programmed.
• If programmed with a negative sign (I-), the boss is
machined with the given pass (step) except the last pass
that machines the rest.
In either case, the cycle limits the step to the cutting length
assigned to the tool in the tool table.
Fz Penetration feedrate.
F Surface milling feedrate.
S Spindle speed.
T Roughing tool.
If programmed T=0, there is no roughing.
D Tool offset.
(e)(d)
To Next Page
Loading...
