Programming manual
CNC 8070
CYCLE EDITOR
Rectangular Boss
12.
(SOFT V02.0X)
297
Machining direction (icon).
Clockwise with icon
(f)
.
Counterclockwise with icon
(g)
.
Finishing parameters:
The finishing operation is carried out in two stages.
First, it machines the base of the boss and then the side walls, with
tangential entry and exit.
The finishing operation defining parameters are:
Spindle turning direction (icon).
Clockwise with icon
(d)
.
Counterclockwise with icon
(e)
.
Machining direction (icon).
Clockwise with icon
(f)
.
Counterclockwise with icon
(g)
.
δ Finishing stock on the side walls.
δz Finishing stock at the base of the boss.
N Number of penetration passes (steps) for the side finishing. If
the resulting step is greater than the cutting length assigned
to the table in the tool table, the step will be limited to that value.
F Surface and side milling feedrate.
S Spindle speed.
T Finishing tool.
If programmed T=0, there is no finishing.
D Tool offset.
(g)(f)
(e)(d)
(g)(f)
To Next Page
Loading...
