Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Circular boss
(SOFT V02.0X)
302
The finishing operation defining parameters are:
Spindle turning direction (icon).
Clockwise with icon
(a)
.
Counterclockwise with icon
(b)
.
Machining direction (icon).
Clockwise with icon
(c)
.
Counterclockwise with icon
(d)
.
Basic operation:
1. It selects the roughing tool and starts the spindle in the requested
direction.
2. Rapid movement (G0) to the roughing starting point and the safety
plane (Zs).
Depending on the starting plane, it first moves in XY and then in
Z or vice versa.
δ Finishing stock on the side walls.
δz Finishing stock at the base of the boss.
N Number of penetration passes (steps) for the side finishing. If
the resulting step is greater than the cutting length assigned
to the table in the tool table, the step will be limited to that value.
F Surface and side milling feedrate.
S Spindle speed.
T Finishing tool.
If programmed T=0, there is no finishing.
D Tool offset.
(b)(a)
(d)(c)
To Next Page
Loading...
