Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Surface milling
(SOFT V02.0X)
304
12.17 Surface milling
The way the roughing and finishing blocks of this cycle are joined will
be the one previously set by the user with the instructions #HSC, G5,
G50 or G7. We recommend to use #HSC or G5 controlling the shape
of the corner with the instruction #ROUNDPAR.
Geometric parameters:
Machining direction (icon).
Bidirectional in X
(a)
, Bidirectional in Y
(b)
.
Unidirectional in X
(c)
, Unidirectional in Y
(d)
.
Corner where the surface milling begins (icon).
Any of the 4 corners may be selected.
X, Y, L, H
Surface to be milled.
Define one of the corners (X, Y), the length (L) and the width
(H) of the surfaced to be milled.
The (X, Y) point needs not coincide with the corner selected to
begin machining. The sign of L and H indicates the orientation
with respect to the XY point.
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
το Angle, in degrees, between the surface and the abscissa axis.
The turn is carried out on the defined corner, X,Y point.
(c)
(a)
(b) (d)
To Next Page
Loading...
