Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Point-to-point profile
(SOFT V02.0X)
308
12.18 Point-to-point profile
The way the roughing and finishing blocks of this cycle are joined will
be the one previously set by the user with the instructions #HSC, G5,
G50 or G7. We recommend to use #HSC or G5 controlling the shape
of the corner with the instruction #ROUNDPAR.
Geometric parameters:
All intermediate points P2 to P11 have an icon to indicate the
type of corner: square
(a)
, rounded
(b)
or chamfered
(c)
.
For rounded or chamfered corners, indicate the rounding radius
or chamfer size.
When not using all 12 points, define the first unused point with
the same coordinates as those of the last point of the profile.
X1, Y1 Profile entry point
R1 Radius of the tangential entry to the profile
P1..P12 Points of the profile.
Rn Radius of the tangential exit from the profile
Xn, Yn Profile exit point
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
(b)(a)
(c)
To Next Page
Loading...
