Programming manual
CNC 8070
CYCLE EDITOR
Point-to-point profile
12.
(SOFT V02.0X)
311
4.5. Rapid movement to the starting point X1Y1.
5. It selects the finishing tool and starts the spindle in the requested
direction.
6. Finishing operation.
7. Penetration to the bottom at feedrate "Fz".
7.1. Profile milling at feedrate "F" and tangential entry if it has
been programmed.
7.2. Exit to point XnYn with tangential exit if it has been
programmed.
8. Rapid withdrawal (G0) up to the safety plane (Zs).
To Next Page
Loading...
