Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Profile
(SOFT V02.0X)
312
12.19 Profile
The way the roughing and finishing blocks of this cycle are joined will
be the one previously set by the user with the instructions #HSC, G5,
G50 or G7. We recommend to use #HSC or G5 controlling the shape
of the corner with the instruction #ROUNDPAR.
Geometric parameters:
Name of the profile.
To machine with tangential entry and exit, define these values
inside the profile.
Roughing parameters:
The roughing operation mills the profile leaving the finishing stock δ.
This stock is defined as finishing parameter.
X, Y Profile entry point
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
To Next Page
Loading...
